Research Information System
Journal of Prosthodontics, vol.23, no.6, pp.445-455, 2014 (SCI-Expanded)
Purpose: The objectives of this study were to evaluate the fracture resistance (FR), flexural strength (FS), and shear bond strength (SBS) of zirconia framework material veneered with different methods and to assess the stress distributions using finite element analysis (FEA). Materials and Methods: Zirconia frameworks fabricated in the forms of crowns for FR, bars for FS, and disks for SBS (N = 90, n = 10) were veneered with either (a) file splitting (CAD-on) (CD), (b) layering (L), or (c) overpressing (P) methods. For crown specimens, stainless steel dies (N = 30; 1 mm chamfer) were scanned using the labside contrast spray. A bilayered design was produced for CD, whereas a reduced design (1 mm) was used for L and P to support the veneer by computer-aided design and manufacturing. For bar (1.5 × 5 × 25 mm3) and disk (2.5 mm diameter, 2.5 mm height) specimens, zirconia blocks were sectioned under water cooling with a low-speed diamond saw and sintered. To prepare the suprastructures in the appropriate shapes for the three mechanical tests, nano-fluorapatite ceramic was layered and fired for L, fluorapatite-ceramic was pressed for P, and the milled lithium-disilicate ceramics were fused with zirconia by a thixotropic glass ceramic for CD and then sintered for crystallization of veneering ceramic. Crowns were then cemented to the metal dies. All specimens were stored at 37°C, 100% humidity for 48 hours. Mechanical tests were performed, and data were statistically analyzed (ANOVA, Tukey's, α = 0.05). Stereomicroscopy and scanning electron microscopy (SEM) were used to evaluate the failure modes and surface structure. FEA modeling of the crowns was obtained. Results: Mean FR values (N ± SD) of CD (4408 ± 608) and L (4323 ± 462) were higher than P (2507 ± 594) (p < 0.05). Mean FS values (MPa ± SD) of CD (583 ± 63) and P (566 ± 54) were higher than L (428 ± 41) (p < 0.05). Mean SBS values (MPa ± SD) of CD (49 ± 6) (p < 0.05) were higher than L (28 ± 5) and P (30 ± 8). For crown restorations, while cohesive failures within ceramic and zirconia were seen in CD, cohesive failures within ceramic were found in both L and P. Results were verified by FEA. Conclusion: The file splitting technique showed higher bonding values in all mechanical tests, whereas a layering technique increased the FR when an anatomical core design was employed. Clinical significance: File splitting (CAD-on) or layering veneering ceramic on zirconia with a reduced framework design may reduce ceramic chipping. © 2014 by the American College of Prosthodontists.